Procom MD5TPA-BB Manuel d'installation télécharger pdf (Page 13)

www.usaprocom.com

13200042-01B

12

1

/8"

14

1

/2"

Min.

6

3

/4"

Min.

Adjoining Wall

Only Insert Mounting

Screws Through Last

Hole On Each End

Floor

10

5

/

8

"

Min.

17

3

/

8

"

18

1

/

2

"

Min.

Only Insert Mounting

Screws Through Last

Hole On Each End

Floor

Adjoining Wall

Figure 9 - Mounting Bracket Clearances

Model: MD2TPA

Models:

MD3TPA, MD5TPA

MD3TPA-BB, MD5TPA-BB

Figure 10 - Folding Anchor

Figure 11 - Popping Open Anchor Wings

For Thin Walls

2. Mark screw locations on wall (see Figure

9). Note: Mark only last hole on each end

of mounting bracket. Insert mounting

screws through these holes only.

3. Remove tape and mounting bracket from

wall.

Attaching Mounting Bracket To Wall

Note: Wall anchors, mounting screws, and

spacers are in hardware package. The hard-

ware package is provided with heater.

Attaching to Wall Stud Method

For attaching mounting bracket to wall studs:

1. Drill holes at marked locations using 9/64"

drill bit.

2. Place mounting bracket onto wall. Line

up last hole on each end of bracket with

holes drilled in wall.

3. Insert mounting screws through bracket

and into wall studs.

4. Tighten screws until mounting bracket is

rmly fastened to wall studs.

Attaching to Wall Anchor Method

For attaching mounting bracket to hollow

walls (wall areas between studs) or solid walls

(concrete or masonry):

1. Drill holes at marked locations using

5/16" drill bit. For solid walls (concrete or

masonry), drill at least 1" deep.

2. Fold wall anchor as shown in Figure 10.

3. Insert wall anchor (wings rst) into hole.

Tap anchor ush to wall.

4. For thin walls (1/2" or less), insert red key

into wall anchor. Push red key to “pop”

open anchor wings (see Figure 11).

IMPORTANT: Do not hammer anchor key! For

thick walls (over 1/2" thick) or solid walls, do

not pop open wings.

INSTALLATION

1. Attaching to wall stud: This method pro-

vides the strongest hold. Insert mounting

screws through mounting bracket and into

wall studs.

2. Attaching to wall anchor: This method

allows you to attach mounting bracket to

hollow walls (wall areas between studs)

or to solid walls (concrete or masonry).

Decide which method better suits your needs.

Either method will provide a secure hold for

the mounting bracket.

Marking Screw Locations

1. Tape mounting bracket to wall where

heater will be located. Make sure mount-

ing bracket is level.

WARNING: Maintain minimum

clearances shown in Figure

4, page 10. If you can, provide

greater clearances from oor and

joining wall.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Commentaires sur ces manuels

Pas de commentaire