Procom MD5TPA-BB Manuel du propriétaire télécharger pdf (Page 13)

Attaching to Wall Anchor Method

For attaching mounting bracket to hollow walls (wall areas between studs)

or solid walls (concrete or masonry):

1. Drill holes at marked locations using 5/16-inch drill bit. For solid walls

(concrete or masonry), drill at least 1 inch deep.

2. Fold wall anchor as shown in Figure 8.

3. Insert wall anchor (wings rst) into hole. Tap anchor ush to wall.

4. For thin walls (1/2 inch or less), insert red key into wall anchor. Push

red key to “pop” open anchor wings (see Figure 9).

IMPORTANT: Do not hammer anchor key! For thick walls (over 1/2

inch thick) or solid walls, do not pop open wings.

5. Place mounting bracket onto wall. Line up last hole on each end of

bracket with wall anchors.

6. Insert mounting screws through bracket and into wall anchors.

7. Tighten screws until mounting bracket is rmly fastened to wall.

Placing Heater On Mounting Bracket

1. Locate two horizontal slots on back panel of heater (see Figure 10).

2. Place heater onto mounting bracket. Slide horizontal slots onto stand-

out tabs on mounting bracket.

Installing Bottom Mounting Bracket

1. Install bottom bracket to heater bottom with two screws. It may be

more convenient to remove heater from wall bracket to attach.

2. Place heater on wall mounting bracket.

3. Mark screw locations on wall.

4. Remove heater from mounting bracket.

5. If installing bottom mounting screws into hollow or solid wall, install

wall anchors. Follow steps 1 through 4 under “Attaching To Wall An-

chor Method”. If installing bottom mounting screw into wall stud, drill

holes at marked locations using 9/64-inch drill bit.

6. Replace heater onto mounting bracket.

7. Using the longest screw and plastic spacer provided, drive screw from

the inside of the heater body through hole shown in gures 11A and

11B and into the hole at the end of the plastic spacer. (For MD2TPA

see Figure 11A), (For MD3TPA,MD3TPA-BB,MD5TPA,and MD5TPA-

BB see Figure 11B)

8. Tighten the screw until heater is rmly secured to wall. Do not over-

tighten spacer onto the wall. (For MD2TPA see Figure 11C), (For

MD3TPA,MD3TPA-BB,MD5TPA,and MD5TPA-BB see Figure 11D)

Figure 8 - Folding Anchor

Figure 9 - Popping Open

Anchor Wing For Thin Walls

Figure 10 - Mounting Heater

Onto Mounting Bracket

Figure 11A

Figure 11B

Figure 11C Figure 11D

Screw

Shell

Plastic

Spacer

Screw

Shell

Plastic

Spacer

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

Commentaires sur ces manuels

Pas de commentaire

Procom MD5TPA-BB Manuel du propriétaire Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffages d'appoint Procom MD5TPA-BB