Procom PCFD32RT-M-HC Manuel d'instructions

– Do not store or use gasoline or other flammable vapors and liquids in vicinity of this or any other appliance. WHAT TO DO I

10 INSTALLATION NOTICE: This heater is intended for use as supplemental heat. Use this heater along with your primary heating system. Do not inst

11 NOTE: When heater is installed directly on carpeting, tile or other combustible material, other than wood flooring, the heater must be installed

12 IMPORTANT: When finishing your firebox, Combustible materials such as wall board, gypsum board, sheet rock, drywall, plywood, etc, must have ½ -

13 CONNECTING TO GAS SUPPLY WARNING: A qualified technician must connect heater to gas supply. Follow all local codes. WARNING: This appliance

14 CAUTION: Use only new black iron or steel pipe. Internally tinned copper tubing may be used in certain areas. Check your local codes. Use pipe o

15 CAUTION: Two gas line installations at the same time are prohibited. The access plate to the simple switching means shall not be opened while th

16 CHECKING GAS CONNECTIONS WARNING: Test all gas piping and connections for leaks after installing or servicing. Correct all leaks immediatel

17 Installation for Decorative Trim: 1. Installation for Left/Right Decorative Trim:  Wedge two fl

18 INSTALLING LOGS WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts included may result in

19 STEP 7: Insert the pinhole on the upper part of log 7 in the pin on log 1, log 3 and log 5. STEP

2 TABLE OF CONTENTS Important Safety Information ...

20 OPERATION FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result c

21 LIGHTING INSTRUCTIONS 1. STOP! Read the safety information on the front and back of the warning plate on page 20. 2. Make sure manual

22 REMOTE CONTROL OPERATION MATCHING SECURITY CODES When matching security codes, be sure slide button on the receiver is in the REMOTE posit

23 OFF OPERATION Press the OFF key and the appliance flame will shut off. During this time the LCD screen will show OF (figure 30). After 3 second

24 INSPECTING BURNERS Check pilot flame pattern and burner flame patterns often. PILOT FLAME PATTERN 1. Turn control knob to pilot position 2. I

25 CARE AND MAINTENANCE WARNING: Failure to keep primary air openings of burners clean may result in sooting and property damage. CAUTION: Yo

26 TROUBLESHOOTING WARNING: If you smell gas:  Shut off gas supply.  Do not try to light any appliance.  Do not touch any electrical swi

27 OBSERVED PROBLEM PROBABLE CAUSE REMEDY ODS/pilot lights but flame goes out w

28 OBSERVED PROBLEM PROBABLE CAUSE REMEDY Slight smoke or odor during initial operati

29 REPLACEMENT PARTS NOTE: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty. PARTS

3 IMPORTANT SAFETY INFORMATION IMPORTANT: Read this owner’s manual carefully and completely before trying to assemble, operate, or service this he

30 PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts

31

32 WARRANTY INFORMATION Keep This Warranty IMPORTANT: We urge you to fill your warranty registration card within TEN (10) days of date of installat

4 1. Do not place Propane/LP supply tank(s) inside any structure. Place Propane/LP supply tank(s) outdoors. 2. This heater needs fresh air ventil

5 PRODUCT FEATURES SAFETY PILOT This heater has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot shuts off the

6 UNPACKING 1. Remove top inner pack. 2. Tilt carton so that heater is upright. 3

7 AIR FOR COMBUSTION AND VENTILATION WARNING: If the area in which the heater may be operated does not meet the required volume for indoor combu

8 2. Divide the space volume by 50 cu. ft. to determine the maximum BTU/hr the space can support. __________ (volume of space) ÷ 50 cu. ft.= (Max

9 Ventilation Air From Inside Building This fresh air would come from adjoining unconfined space. When ventilating to an adjoining unconfined s